Owner`s manual

....

Setting Up

2. Setting Up

Please check the components which should include:

1 Basic device (M2 or M8)

2 Remote controller

3 Bag for the remote controller

4 Cable to connect remote controller to device

5 Power supply

6 This Manual

Connecting the MULTISTATION to an existing setup only takes a few minutes. Of course, a headphone would allow

you to enjoy music on the MULTISTATION right away. But you might prefer to use the MULTISTATION with an

already existing music system. For this, follow these steps:

1 Connect the MIDI output of a keyboard with one of the MIDI inputs of the

MU LT IS TAT I O N.

2 Connect the Line Out 1 and Line Out 2 at the rear panel of the MULTISTATION to the

inputs of a sound system.

3 Connect the remote controller to the basic device.

4 If applicable, plug the footswitch into the FOOTSW jack on the front panel of the device..

5 Connect the power cable, and turn the power of the MULTISTATION on.

After these few steps the MULTISTATION is ready to go.