Owner`s manual

Reference Section
122
2 Delete processors... This entry gives you access from this screen to the processor list,
similar to selecting the allproc icon in the icon line. After selecting this function, an
additional selections window will open. You have the following options there:
• All MIDI processors Removes all processors that are defined anywhere.
• Only on selected connector Removes the processor of a specific port. You can see that
both areas communicate with each other. You may first select a port in the routing area
and afterwards switch to the [allproc] screen to delete the processors of aspecific port,
as described here.
• Only on selected con. & channel Removes the processors that are assigned to a
specific channel on a specific port. The same explanation of the previous section
applies here.
3 Layers When selecting this function an additional menu opens where you may select the
different layers. If you set up a split, afterwards, the configurations will only be valid for
the layer that is indicated in the title line. More about layers can be found in chapter 9.8 -
Icon Line in the Player / “layers” Icon - on page 66.
10.15 Icon Line in the MIDI Module / [velocity] Icon
You will find the icon line by selecting the MIDI module in the main screen or by pressing the MIDI key in the
operation panel of the remote controller. If you select the
velocity icon in the icon line, the following screen will
appear: