Owner`s manual

....
MIDI Module
119
2 Delete processors... This entry gives you acces to the processor list, as it is visible after
selecting the allproc icon in the icon line. After selecting this function, another window
will open where you have the following options:
• All MIDI processors Removes all processors that are defined anywhere.
• Only on selected connector Removes the processors of a specific port. You may
recognize here that both areas communicate with each other. This allows you to select
a connector in the routing part and then to switch to the [allproc] screen to remove a
processor of a specific connector with the function described here.
• Only on selected con. & channel Removes all processors that are assigned to a
specific channel on a specific port. The same explanation of the previous section
applies here.
3 Layers When selecting this function, another menu will open in which you may select
different layers. If you set a filter afterwards, all configurations will apply exclusively to
the layer that is indicated on the title line. More about the topic layers can be found in
chapter 9.8 - Icon Line in the Player / “layers” Icon - on page 66.
10.12 Icon Line in the MIDI Module / [split] Icon
You will find the icon line by selecting the MIDI module in the main screen or by pressing the MIDI key on the
control panel of the remote controller. If you select the
filter icon afterwards, the following screen will open: