Owner`s manual

Reference Section
114
5 Programm change Sends a programm change command. In detail, you may configure:
• Port Select here the input or output on which the processor should work. Please notice
that you also have access to the internal tone generator as well as to a connected
external daughterboard.
• Channel Select here the MIDI channel on which the processor should work.
• Programm No. Configure here the programm number that should be send.
• BankL (ctrl32) Configure here the Least Significant Bit, if you want to work with
bank change commands. For more information, refer to the manual of the external tone
generator. (Will only send command if the field BankDef is activated.)
• BankM (ctrl0) Configure here the Most Significant Bit, if you want to work with bank
change commands. For more information, refer to the manual of the external tone
generator. (Will only send command if the field BankDef is activated.)
• Button [Send] Sends the just defined command for control purposes.
• Selection field BankDef If a check mark is set here, a bank change command will be
sent before the program change command. The necessary data can be entered in the
fields BankL and BankM.
• Close the window with Yes to apply the settings. Select No to abort the action.
6 Send MIDI Stream Sends MIDI System-Exclusive-Files. ATTENTION: You should
only perform changes in this area, if you are aware of the consequences of what you are
doing. Faulty or incorrect sent Sys-Ex-Files may reprogram connected MIDI devices in
such a way that they might cease to function properly. In detail, you may configure:
• Port Select here the input or output on which the processor should work. Please notice
that you also have access to the internal tone generator as well as to a connected
external daughterboard.
• Edit Data Takes you to an input area, where you may define the Sys-Ex-Files to be
sent.
• Close the window with Yes to apply the settings. Select No to abort the action.
7 MIDI to patch control Defines how the currently active patch will react to external
program change commands. In detail you may configure:
• Port Select here the input or output on which the processor should work.
• Channel Channel Select here the MIDI channel on which the processor should work.
• ModeBankSel: Defines the scheme by which the banks will be switched. You have the
following options:
- Controller 0/32