Owner`s manual

Reference Section
110
In this screen you do not only route the complete inputs or outputs, but also the MIDI channels. The routing works
similarl to the [MIDI cons] screen, where you simply touch the buttons that should be connected with each other. In
addition to the possibility to select the individual inputs and outputs (in the selection menu), the screen will also show
you a graphic which allows you to select the individual MIDI channels. The left side of the main area is for the inputs
and the right side for the outputs. Take a look at an example to demonstrate this concept:
You want to send the data that you receive on MIDI channel 1, input 1 of the MULTISTATION, to MIDI channel 5 of
output 8. Proceed the following way:
1 Open the drop-down menu entitled Input and select there In 1 (=Input 1).
2 Highlight button 1 on the left side of the main area, which represents MIDI channel 1.
3 Open the drop-down menu Output and select there Out 8 (=Output 8).
4 Highlight button 5 on the right side of the the main area, which represents MIDI channel 5.
You have already programmed the routing. Likewise, this screen allows you multiple selections. You may activate
without hesitation in both main areas several MIDI channels. Also consider that this screen is related to the [MIDI con]
screen. If you perform a routing for a channel at the above described screen, which has not been programmed up to
now, the connection will be supplemented. You may check this easily, by clicking on the
cons icon; the new
connection will be displayed there.
In the main area below the graphics with the channel numbers you will find two additional buttons. These have the fol-
lowing function:
1 omni Indicates that you are dealing with routings and that it has been switched to the
“Route Omni” mode.
2 orig Revokes the connection that has been made in the “Route Omni” mode. In this case,
it will not be possible to remove individual channels from the routing, since it is only pos-
sible to delete the routing completely by deleting the connection. The button orig deletes
the lock and releases the individual channels.
10.6 Functions Menu in the [chan.] Screen
This menu provides functions to delete routings in the current screen. In addition, it allows
you to access a different layer. You have the following options: