Owner`s manual

Reference Section
106
As already mentioned, you may create basic connections in this screen. This is done by simply clicking the ports that
you want to connect to each other, one after another. You may start with the input as well as the output. Please
remember:
When selecting the port from which a routing is sent it is always inversely shown:
To adjust a routing at all you have to switch Show routings to e.g. Route Omni. Otherwise it´s not possible to make
connections at all. This simply is to avoid errors.
An example: You want to route all incoming signals at input 1 to output 2. Press first the [MIDI] key on the operation
panel of the remote controller, the [MIDI con] opens in which you may perform the routing. Now, click on the icon for
the input 1. The icon will be dislpayed inversely, as in the above figure. To route the incoming signals from this port to
output 2, likewise highlight the icon for output 2. This icon is now colored black and the routing activated.
If you switch briefly to another screen and then return, you will see the following figure:
You can see that input 1 and output 2 are connected. MIDI signals that come to input 1 are now routed to output 2. This
depiction is very clear with the M2, since it has only a few ports. The M8 will accordingly display more icons.
Tip… To verify where an input is routed to, switch briefly to Show routing in the selection menu. Select the input you
want to check the routing of. Result: The related output wil be displayed in black.