WHS-209BESS1
Contents Safety warnings Meaning of safety warning symbols Safety warnings Representative meaning of the safety warning symbol ··········1 Electricity-related matters······················2 Related matters for usage······················2 Related matters of abandoning····················2 Correct manipulation of the beer machine Names of each component······················3 Placement·····························3 Starting······························3 Prohibition symbols The symbols indicate matters
Correct manipulation of the beer machine Safety warnings Names of each component Electricity-related matters Do not pull the power cord when pull the power plug of the beer machine. Grasp the plug firmly and pull out the plug directly. Don't pull the plug with wet hands. The power cord should be fixed at the back of the box instead of being exposed outsides and dangling to prevent accidents. Never damage the power cord. Avoid using them when the power cord is damaged or the plug becomes frayed.
Introduction to the beer machine's functions Maintenance of the beer machine Cleaning Operation panel Deep Chill Temperature Temperature drop rise Display module The dust of the back of beer machine and the ground needs cleaning up in time in order to improve the cooling effect and help save energy at the same time. The interior of beer machine should be cleaned regularly. When cleaning, use a soft towel or sponge which is dipped in water or non-corrosive neutral detergent.
DRAUGHT BEER TROUBLE GUIDE CLOUDY BEER When beer in glass appears hazy, and not clear. 3) Not enough pressure. 3) Increase pressure if beer runs too slowly. Correct flow is to fill 4) Defective Thomas and Tongue Vents. Pressure is shut off. 4) Check all washers frequently, particularly the air vents. A clogged vent will obstruct the flow of air or CO 2. Check source of pressure. Check power source when air compressor is used. Air compressor should never be connected to light switch.
OFF-TASTE BEER Often bitter and bitey, sometimes completely odor, carrying an unpleasant taste. Beer lines should be flushed after each barrel is empty. Maintain fresh, Clean, sanitary conditions at bar. Smoke, kitchen odors, fly sprays, and disinfectants will harm the tast and flavor of beer, making it unpalatable. These conditions, as described, may come from an air source, or from actual contact with the glass at bar.
Answers to FAQ 10) Excess CO 2. 11) Not enough pressure. No pressure. 12) Old Beer. 10) Adjust pressure when using CO 2 as low as possible, however, remembering that the applied pressure must be slightly higher than the internal pressure of the beer (no more than 18 lbs. should be applied.) The colder the beer and the higher the applied CO 2 pressure, the more rapid the absorption of CO 2 by the beer. This over-carbonates the beer, causing Wild Beer. 11) Check for defective air vents.
Instructions to beer accessory installation Diagram of overall structure Beer tower assembly Upper cover guardrail Water box Top cover Display and control device Cabinet Transparent hose(Beer tube) CO 2 regulator valve The red CO 2 soft tube Mixed ball valve CO 2 can supporter and bolt The beer kegs barrels of handle Door CO 2 gas cylinder Beer barrels Beer can bottom pad Universal wheels Introduction to installation components Handle to take wine Wine faucet Main switch of CO 2 gas cylinder Be
2.Install the beer tower assembly and the mixed ball valve: (1) Plug the beer tower assembly into the beer top cover to fix: A.3.0 inch: does not require tower buckle. Put beer tower directly at the surface hole of the beer machine roof. Fix the beer tower assembly with screws directly on the roof of the beer machine. (See Figure 3) B.2.5 inch: need tower buckle. Put the beer tower at the surface hole of the beer machine with 60 degrees inclined, and rotate 60 degrees clockwise along the card slot.
