DE HU MI DI FI ER Model: WDK30AE7N WDK50AE7N Before operating this product, please read the instructions carefully and save this manual for future use.
CONTENTS SAFETY PRECAUTIONS Warning ..........................................................................................................................................2 Caution ...........................................................................................................................................2 Electrical information ......................................................................................................................
SAFETY PRECAUTIONS To prevent injury to the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring of instructions may cause harm or damage. The seriousness is classified by the following indications. WARNING This symbol indicates the possibility of death or serious injury. CAUTION This symbol indicates the possibility of injury or damage to property. Meanings of symbols used in this manual are as shown below. Never do this.
SAFETY PRECAUTIONS CAUTION Do not cover the intake or exhaust openings with cloths or towels. ! A lack of air flow can lead to overheating and fire. Never insert your finger or other foreign objects into grills or openings. Take special care to warn children of these dangers. Always insert the filters securely. Clean filter once every two weeks. Operation without filters may cause failure. Do not use in areas where chemicals are handled.
CONTROL PADS ON THE DEHUMIDIFIER NOTE: The control panel of the unit you purchased may be slightly different according to the models. Clean filter indicator light 7 High fan indicator light 2 3 Low fan indicator light Bucket full indicator light Continuous operation on indicator light 1 Timer on/off indicator light 6 5 4 Auto defrost operation on indicator light Fig.
CONTROL PADS ON THE DEHUMIDIFIER 7 Display Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while setting, then shows the actual ( 5% accuracy) room % humidity level in a range of 30% RH(Relative Humidity) to 90%RH(Relative Humidity). Error Codes and Protection Code: AS- Humidity sensor error--Unplug the unit and plug it back in. If error repeats, call for service. ES- Temperature sensor error-- Unplug the unit and plug it back in. If error repeats, call for service.
IDENTIFICATION OF PARTS Identification of par ts 1 Front 6 2 1 Control panel 4 2 3 4 5 Air intake grille Air outlet grille Air filter (behind the grille) 5 6 Handle (both sides) 3 Water bucket Fig.2 Rear 1 Drain hose outlet 2 Caster 3 Power Cord and plug 4 Band(Used only when storing the unit.) 1 2 NOTE: All the pictures in the manual are for explanation purposes only. The actual shape of the unit you purchased may be slightly different, but the operations and functions are the same.
OPERATING THE UNIT Positioning the unit A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed storage area, such as a closet, unless there is adequate circulation of air in and out of the area. Do not use outdoors. This dehumidifer is intended for indoor residential applications only. This dehumidifier should not be used for commercial or industrial applications.
OPERATING THE UNIT 1. Pull out the bucket a little. Removing the collected water There are two ways to remove collected water. 1. Use the bucket When the unit is off,if the bucket is full, the unit will beep 8 times and the Full indicator light will flash, the digital display shows P2. When the unit is on,if the bucket is full, the compressor Fig.5 turns off and the fan turns off after 30 seconds for drying 2.
CARE AND MAINTENANCE Care and cleaning of the dehumidifier Turn the dehumidifier off and remove the plug from the wall outlet before cleaning. 1. Clean the Grille and Case Use water and a mild detergent. Do not use bleach or abrasives. Do not splash water directly onto the main unit. Doing so may cause an electrical shock, cause the insulation to deteriorate, or cause the unit to rust. The air intake and outlet grilles get soiled easily, so use a vacuum attachment or brush to clean. 2.
TROUBLESHOOTING TIPS Before calling for service, review the chart below first yourself. Problem Unit does not start Dehumidifier does not dry the air as it should What to check , Make sure the dehumidifier s plug is pushed completely into the outlet. Check the house fuse/circuit breaker box. Dehumidifier has reached its preset level or bucket is full. Water bucket is not in the proper position. Did not allow enough time to remove the moisture.
Midea 11 9
90 90 90 12
The design and specifications are subject to change without prior notice for product improvement. Consult with the sales agency or manufacturer for details.
