User Instructions

ANTI-TIP BLOCK ELECTRICAL OUTLET
S
u
g
g
e
s
t
e
d
e
l
e
c
t
r
i
c
a
l
o
u
t
l
e
t
l
o
c
a
t
i
o
n
5
''
4
'
'
Anti Tip
block
(
6
'
'
)
3
1
2
'
Figure 3
Figure 4
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
To reduce the risk of tipping of the drawer, the Anti-Tip block must be properly
13/16- installed located 14 inches above the floor on which the Microwave
Drawer will sit. The 6-inch Anti-Tip block must be
provided by the installer.
See Figures 1 and 3. The
Anti-Tip block prevents serious injury that might result
from spilled hot liquids.
If the Microwave Drawer is ever moved to a different
location, the Anti-Tip block must also be moved and
installed , When installed to the
the wall make sure that screws completely penetrate the dry wall and are
secured in wood or metal so that the block is totally stable. When fastening,
be sure that the screws do not
penetrate electrical wiring or plumbing.
The electrical
requirements are a 120 volt 60 Hz, AC
o
nly,l5 amp. or more protected electrical supply.
recommended that a separate circuit serving only this
appliance be provided.
The drawer is equipped with a 3-prong grounding plug,
It must be plugged into a wall
properly installed and grounded. Should you only
have 2-prong outlet,
have a qualified electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or electrical
Instructions, consult
a qualified electrician or service person.
*Can also be installed using an electrical outlet in
an adjacent cabinet within the area
where the provided electrical cord can reach.Always check electrical codes ,for requirements.
It is
receptacle that is
11