Owner's Manual

Page 15
INSTALLATION
INSTRUCTIONS
C. Align the hole in the top rail with those in the top of the unit as shown in Fig. E.
D. Secure the top rail to the unit with the 3/8” Screws as shown in Fig. F.
Fig. E Fig. F
WARNING
For safety reasons, all four
(4) screws MUST be securely
fastened.
3. Install Accordion Panels on Air Conditioner
NOTICE
The Top rail and Sliding Panels on each side are offset to provide the proper pitch to
the rear of the unit 5/16” (8mm). This is necessary for proper condensate management
and drainage. If you are not using the Side Panels for any reason, this pitch to the rear
must be maintained.
Place unit on the floor, a bench or a table. There is a left and right side accordion panel;
be sure to use the proper panel for each side. When installed, the flange for securing the
panel in place to the window sill will be facing into the room.
A. Hold the side panel in one hand and gently pull back the center to free the open end.
See Fig. 1.
B. Slide the free end “
“ section of the panel directly into the cabinet as shown in Fig. 2.
Slide the panel down. Be sure to leave enough space to slip the top and bottom of the
frame into the rails on the cabinet.
C. Once the panel has been installed on the side of the cabinet, make sure it sits securely
inside the frame channel by making slight adjustments. Slide the top and bottom ends
of the frame into the top and bottom rails of the cabinet. Fig. 3.
Fig .1 Fig .2
"
" section
Bottom Rail
Top Rail
Fig .3
Top left
Bottom Rail
Top Rail Top right
Fig .4
D. Slide the panel all the way in and repeat
on the other side.
NOTICE
If storm window blocks AC, see Fig. 11.