Warranty

INSTALLATION INSTRUCTIONS

Wall Sleeve Brands:

#8 White Westinghouse/Frigidaire/

Carrier 52F Series ( 16 +17 Deep)

1.Remove existing rear grille as shown on Page

6 of this manual and replace with provided

louvered rear panel. Install as shown here.

NOTE: You may need to drill holes in flange of

existing sleeve to match new rear grille.

2. Attach (1)1 x3/8 x25 long seal in the center

at the top of the sleeve. Remove the backing

paper and press into position.

3. Attach (2) 1 x3/8 x14 seals to the left and

right sides of the sleeve.

4. Attach (2) 1 x3/4 x14 long seals vertically 4.5

from the left side of the sleeve .Attach the other

1 x3/4 x14 long seal 4 from the right side of the

sleeve.

5. Center unit and gently slide unit into sleeve.

6. Before sliding all-the-way back, remove 2nd

screw from front on left side of unit.

7. Remove the plastic washer from the screw.

8. Screw and attach the other end of the ground

wire to the unit as shown in picture. Make sure

that the toothed washer is against the cabinet.

9. Slide the unit completely to the rear to ensure

a good seal, making sure the ground wire does

not become tangled.

10.Seal & Frame the unit as described on page 17.

11. If you have difficulty with mounting the grill to

the sleeve, follow the instructions for direct

mounting on Page 16.