Use and Care Guide

16
Refrigerator
Safety
Operating
Requirements
Parts and
Features
Installation
Refrigerator
Use
Refrigerator
Care
Troubleshooting
Before
Use
9. Slide the hose through the hole of the
security bracket and the foam insulation
pad, with the pad facing the rear of the
refrigerator and affix the hose security
bracket and foam insulation pad in place
using the two (2) screws provided.
10. Push the water supply hose into the water
inlet hose as far as it will go and tighten the
Nylon compression nut onto the water inlet
hose until it is secure/tight.
Then tighten the nut until it is secure but DO
NOT overtighten using a wrench.
(11)Water
Inlet Tube
(3)Water
Tubing
11. Install the leveling bracket to the bottom
of the ice maker assembly with the screw
provided.
DO NOT TIGHTEN.
This bracket will be tightened later in this
installation.
Leveling
Bracket(7)
Screw(6)
12. Start two (2) long ice maker mounting
screws into the freezer wall.
Turn each screw five turns clockwise.
(5) Ice Maker
Mounting Screws
13. With the ice maker in one hand, plug the
wiring harness connector into the connector
mounted on the top freezer panel.
Make sure the connection is tight and secure.
Wiring Harness
Connector