Installation Instructions

 Page 9 
COOL operation
• Press the “MODE” button until the “COOL”
indicator light comes on.
• Press the ADJUST buttons “+” or “-” to
select your desired room temperature. The
temperature can be set within a range of
17°C~30°C/62°F~86°F.
• Press the “FAN SPEED” button to choose
the fanspeed.
DRY operation
• Press the “MODE” button until the “DRY”
indicator light comes on.
• Under this mode, you cannot select a fan
speed or adjust the temperature. The fan
motor operates at LOW speed.
• Keep windows and doors closed for the
best dehumidifying effect.
• Do not put the duct to window.
AUTO operation
• When you set the air conditioner in AUTO
mode, it will automatically select cooling,
heating (cooling only models without),
or fan only operation depending on what
temperature you have selected and the
room temperature.
• The air conditioner will control room
temperature automatically round the
temperature point set by you.
• Under AUTO mode, you can not select
the fan speed.
FAN operation
• Press the “MODE” button until the ”FAN“
indicator light comes on.
• Press the “FAN SPEED” button to choose
the fan speed. The temperature can not
be adjusted.
Operation Instructions
TIMER operation
• When the unit is on, pressing the Timer
button will initiate the Auto-off stop
program, the TIMER OFF indicator light
illuminates. Press the UP or down button
to select the desired time. Press the
TIMER button again within 5 seconds,
the Auto-on start program is initiated.
And the TIMER ON indicator light
illuminates. Press the up or down button
to select the desired Auto-on start time.
• When the unit is off, press the Timer
button to initiate the Auto-on start
program, press it again within five seconds
will initiate the Auto-off stop program.
• Press or hold the UP or DOWN button
to change the Auto time by 0.5 hour
increments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control will
count down the time remaining until start.
• The system will automatically revert
back to display the previous temperature
setting if there is no operation in a 5
seconds period.
• Turning the unit ON or OFF at any time
or adjusting the timer setting to 0.0 will
cancel the Auto Start/Stop timer program.
• When the malfunctionoccurs, the Auto
Start/Stop timed program will also be
cancelled.
SLEEP operation
Press this button, the selected temperature
will increase (cooling) or decrease
(heating) by 1°C/1°F 30 minutes. The
temperature will then increase (cooling)
or decrease (heating) by another 1°C/1°F
after an additional 30 minutes. This new
temperature will be maintained for 7 hours
before it returns to the originally selected
temperature. This ends the Sleep mode
and the unit will continue to operate as
originally programmed.
NOTE
This feature is unavailabe under FAN or
DRY mode.
Operating
Instructions