Installation Instructions

 Page 10 
Operating
Instructions
FOLLOW ME/TEMP SENSING
Feature (optional)
Other Features
NOTE
This feature can be activated from the remote control ONLY. The remote control serves
as a remote thermostat allowing for the precise temperature control at its location.
NOTES
• When the Power is ON, the louver opens fully.
• Press the SWING button on the panel or remote controller to initiate the Auto
swing feature. The louver willl swing up and down automatically.
To activate the Follow Me/Temp Sensing feature, point the remote control towards
the unit and press the Follow Me/Temp Sensing button. The remote display is actual
temperature at its location. The remote control will send this signal to the air conditioner
every 3 minutes interval until press the Follow Me/Temp Sensing button again. If the unit
does not receive the Follow Me/Temp Sensing signal during any 7 minutes interval, the
unit will beep to indicate the Follow Me/Temp Sensing mode has ended.
AUTO-RESTART
If the unit turns off unexpectedly due to the power cut, it will restart with the previous
function setting automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not resume operation in the first 3 minutes. This is to
protect the unit. Operation will automatically start after 3 minutes.
AIR FLOW DIRECTION ADJUSTMENT
Use the remote control or control panel to adjust the air flow direction. Avoid manually
adjusting the louver.
Water drainage
• During dehumidifying mode, remove the upper
drain plug from the back of the unit, install the drain
connector (5/8” universal female mender) with 3/4”
hose (locally purchased). For the models without drain
connector, just attach the drain hose to the hole. Place
the open end of the hose directly over the drain area in
your basement floor.
Remove
the upper
drain plug
¥
Continuous
drain hose