Operation Manual

8
Full-automatic programming:
This function is used to cook after a certain period of time with a certain duration, The food to
be cooked is put into the oven The oven is adjusted to the desired cooking function. The oven
temperature is adjusted to the desired degree depending on the food to be cooked.
First: Press "
" button until you see " Dur " on the timer screen. Use " " " " button to adjust
cooking period for the food you wish to cook. Press "
" button to conrm, the day's time will
appear on the screen and the symbols " A " will begin to continuously light on the screen.
Second: keep pressing on "
" button until you see " End " on the timer screen. When you see
" End " on the timer screen, Use " " " " button to adjust nishing time, Press "
" button to
conrm, the day's time will appear on the screen and the symbol " A " will begin to continuously light
on the screen.The symbol "
" disappears until the time cooking starts.
You can set a time which can be up 23.59 hours after the time obtained by adding the cooking
period to the day's time.
The oven will start operating at the time calculated by deducting the cooking period from the set
nishing time, and will stop at the set nishing time. The timer will give an audible warning and the
symbol "A" will begin to ash .After bringing the cooking function and oven temperature to " 0 "
position. any button less than 3 seconds, it will stop the audible warning.
Pressing "
" for more than 3 seconds set the oven to Manual mode again to use the oven.
Please note Once setting full:-automatic mode all the, time can no t be changed Change. time
means cancle automatice progamme and enter into corresponding mode If you need to reset
automatic mode, need to stop setting the current mode to set the automatice mode according to the
above steps again.
Spectication
1> When setting the date of each function, long press on " " or " " for more than 3 seconds the
date will progressively and rapidly increase or decrease.
2> When setting each of the time function, if there is none operation for 5 minutes then it will return
to manual mode.
3> When setting each of the time function, pressing on "
" for more than 3 seconds can cancel
current setting and enter manual mode.
4> During time function setting, pressing on " + " and "
" for more than 3 seconds, a beep
sounds it can cancle the curent time function setting and enter standby mode.
5> We suggest that you run the oven elements for 15 minutes at 200 degrees to burn off any
residuce from their surfaces.