Use and Care Guide

28
Dryer
Safety
Operation
Requirements
Parts and
Features
Installation
Instructions
Dryer Use
Appendix
Dryer Care
Troubleshooting
CONNECT INLET HOSES
Co l d w a t e r
H o t w a t e r
Co n n e c t d i r e c t l y o r u s e e x t e n s i o n
h o s e w i t h Y c o n n e c t o r
W a t e r I n l e t
CO L D W AT ER S U P P L Y
H O S E T O W AS H ER
If possible install the “Y” connector directly, thread the short extension
hose on to the COLD water supply and snug it by hand; then tighten
it another  turn with pliers. Thread the “Y” connector to the short
extension hose and snug it by hand; then tighten it another  turn with
pliers.
Connect the COLD inlet hose for the washer to the “Y” connector and
snug it by hand; then tighten it another
 turn with pliers.
Connect the straight end of a long hose to the other outlet on the “Y”
connector and snug it by hand. Connect the hose’s 90° coupling to the
brass water inlet on the back of the dryer and snug it by hand. Tighten
each connection of the dryer inlet hose another
 turn with pliers. Turn
on the water and check for leaks at all connections.