Manual

REMOVING THE COLLECTED WATER cont
° Direct the hose to the drain area, making sure there are no kinks that will block the
water flow.
° Select the desired humidity setting and fan speed on the unit. The pump will start when
the bucket isfull.
° The pump operation light will blink once per second if there isan operational failure.
Check the following steps if the light blinks:
-Remove the water bucket from the unit, pull down the pump inlet, remove the filter
and clean it
-Check that the pump drain hose is not kinked or blocked
-Empty the water bucket
-Reinstall the pump and bucket properly. Turn on the unit. If the error repeats, call
for service.
NOTE: Do not place the pump drain hose in a location that can become less than
32°F (O°C). The water can freeze in the hose and cause unit failure.
° Make sure to empty the bucket once a week when using the pump draining feature.
The bucket will always be between 3/4 full and full while using this feature, so it
should be periodically emptied and cleaned out to eliminate any possibility of
mold or mildew. Refer to Section 2 on the next page, "Clean the bucket '.'
° When the pump draining feature is not being used, remove the pump drain hose from
the outlet by squeezing the outlet and pulling the drain hose out. Avoid leaking
water from the hose onto the floor. Reinstall the plug that was removed from
the outlet.
14