Manual

REMOVING THE COLLECTED WATER
There are three ways to remove collectedwater.
1. Use the bucket
* If the bucket is full when the unit is turned off,
the unit will beep 4 times, the Full indicator
light will turn on, and the display will show P2.
* When the bucket becomes full when the unit is
turned on, the compressor turns off, the fan runs
for another 30 seconds to dry water off of the
evaporator coil, the unit will beep 4 times, the
Full indicator light will turn on, and the display
will show P2.
* Slowly pull out the bucket. Grip the left and
right handles securely, and carefully pullout
straight so water does not spill. Refer to
Figures 5 & 6. Do not put the bucket on the
floor because the bottom of the bucket is
uneven_ causing it to fall over and spill the
water.
° Empty the bucket and replace it. The bucket
must be in place and securely seated for the
dehumidifier to operate.
° The machine will re-start when the bucket
is restored inits correct position,assuming
that the 3 minutes safety delay for the
compressor has passed.
NOTES:
* When you remove the bucket, do not touch
any parts inside of the unit. Doing so may
damage the product.
* Be sure to push the bucket gently all the
way into the unit. Banging the bucket against
anything or failing to push it in securely may
cause the unit not to operate.
* If the pump drops when you remove the bucket (See
Fig.7), you must reinstall the pump properly before
replacing the bucket into the unit (See Fig.8). There is
a removable cleanable filter on the end of the pump.
* When you remove the bucket, if there is some
water in the unit you must dry it up before continuing.
* When the unit is on, if the bucket is removed,
compressor will turn off immediately, fan will run
additional 30 seconds, then the unit will beep 4 times
and the digital display shows Eb error code.
* When the unit is off, if the bucket is removed, the unit
will beep 4 times and the digital display shows Eb error
code.
Pull out the bucket o liffle.
Figure 5
Hold both sides of the bucket
with even strength, and pull it
out from the unit.
Figure 6
Pourthe water out.
Pump drops
Figure 7
Reinstall
pump properly
Figure 8
11