Specifications

Press to switch on the appliance. The POWER lamp lights up permanently.

Press to switch the appliance off. The POWER lamp goes out.

As soon as you switch on the appliance, you can can increase/decrease the humidity setting

by pressing these buttons - the settings range from 35% R.H. to 80% R.H in increments of 5.

Dehumidifying starts and stops automatically as soon as the humidity level set is reached.

Press

to start permanent dehumidifying. You can see the current ambient humidity in the display at all

times. Press the button again to quit this mode. The appliance switches to "Standard Mode" automatically

and continues operating until the humidity set is reached.

: When you connect the appliance to the mains for the ﬁrst time, this lamp ﬂashes slowly. It stays

permanently lit after you switch the appliance on (appliance ready for operation). After you switch the

appliance off, the lamp goes out.

: This lamp lights up when the appliance is in continual dehumidifying mode.

: This lamp lights up when the water resevoir is full. The appliance stop operating automatically.

The water resevoir needs to be emptied.

DISPLAY: When the appliance is switched on, the display always shows the current ambient air humidity.

If you press , the setting chosen ﬂashes brieﬂy and then the current ambient air humidity is

displayed again.

CONTROL PANEL

NOTES

1. The appliance initially reacts up to ﬁve minutes after a setting has been changed.

2. If you chose to switch the appliance off, wait 3-5 minutes before switching it back on again.