Operating instructions

56
ELECTRONIC CONTROL PANEL
WATER FULL
Water level indicator Indicator lamp: This illuminates when the water container is full. The appliance stops operating
automatically. The water container must be emptied.
Display When the appliance is activated, the display always shows the current air humidity of the room.
If you press the + and – buttons, your selected setting will flash briefly and the room's current air
humidity will then be displayed again.
Fan (optional) Pressing this button controls the fan. Set the fan to "+" for maximum air dehumidification. When
the air humidity has reduced and a quieter operation is required, set the fan to "–".
"+" indicator lamp: This illuminates when the fan is set to maximum power.
"-" indicator lamp: This illuminates when the fan is set to minimum power for quiet operation.
NOTE
The appliance takes up to 5 minutes to respond to the changed settings. 1.
If you have deactivated the air dehumidifier, wait 3 – 5 minutes before activating again.2.
The integrated fan will run as long as the appliance is activated. If the air humidity in the room rises above the humidity level you 3.
have set, the compressor will also kick-in. When the required air humidity is achieved, the compressor will switch off automati-
cally while the fan continues to run. This difference is perceptible from the minimal noise only at the moment of changeover.