User Manual

Defect codes

The defect codes below may occur during steam functions:

E-06: 1-Water tank is not close well.

E-05: water system abnormal, need to contact for engineer to check, below is the possibilities.

1- The water sensor is abnormal.

2- The water pipe is abnormal.

3- The water pump is abnormal.

4- The water tank is abnormal.

17. Auto Scale Removal Function

For best cleaning results, we recommend you to use a steam oven descaler for descaling steam

microwave oven. Follow the manufacturer’s instructions on the packaging. It is suggested that

descaling function shall be used after the steam function has been run for 20 hours.

1) Power up the system, remove the water tank, inject 1000ml of fresh water into the water tank,

and add a pack of descaling agent.

2) Push the water tank into the appropriate location of the appliance.

3) In standby mode, press “

” button, the display “ ” lights, screen displays default

mode d01, default weight 0.10, corresponding cooking time and “Kg” “Min” light up.

4) Press “

’’ repeatedly, when “CLE’’ indicator lightens, it means to enter Scale removal

function. “Min” and default time “20:00” lighten, tank icon show the current water level (water,

lack of water, full of water), and other icons disappear.

5) Press “

” to start the program.

6) Stay whole 1 minute after the program has nished, take out the water tank and pour the

water in the tank. Thoroughly clean the water tank.

7) Replace the fresh water, repeat steps 3 to 6.

Note: The descaling process shall not be shut down. If the descaling process shuts down before

the end, the entire program must be started from step 3.