User Manual

10
FITTED UNITS
BUILDING IN
INSTALLATION DIMENSIONS
• The appliance is only designed to be fully tted in a kitchen.
• The appliance is not designed to be used as a tabletop appliance or inside a cupboard.
• The tted cabinet must not have a back wall behind the appliance.
• A gap of at least 45 mm must be maintained between the wall and the base or back panel of
the appliance.
• The tted cabinet must have a ventilation opening of 250 cm
2
on the front. To achieve this, cut
back the base panel or t a ventilation grille.
• Ventilation slots and intakes must not be covered.
• The safe operation of the appliance can only be guaranteed if it has been installed in
accordance with these installation instructions.
• The tter shall be liable for any damage resulting from incorrect installation.
• The units into which the appliance is tted must be heat-resistant up to 90 °C.
Do not hold or carry the appliance by the door handle. The door handle cannot hold the weight of
the appliance and may break off.
1. Carefully push the oven into the box, making sure that it is in the centre.
2. Open the door and fasten the oven with the supplied screws.
Note: There shall be gap above the oven.