Installation Instructions

Page 16
(UP/DOWN) Button
Press or hold either left (
-
) or right (
+
)
button until the desired temperature is
seen on the display. This temperature will
be automatically maintained at the set
temperature, between 62°F (17°C) and
86°F (30°C). If you want the display to
read the actual room temperature, see
“To Operate on Fan Only” section.
(MODE) Button
• To choose operating mode, press Mode
button. Each time you press the button, a
mode is selected in a sequence that goes
from Auto, Cool, Dry and Fan. The indicator
light beside will be illuminated and remains
on once the mode is selected.
•
The unit will initiate automatically the
Energy Saver function under Cool, Dry,
Auto (only Auto-Cooling and Auto-Fan)
modes.
Operating on AUTO mode:
• When you set the air conditioner in
AUTO mode, it will automatically select
cooling, heating (selected models only)
or fan only operation depending on what
temperature you have selected and the
room temperature.
• The air conditioner will control room
temperature automatically to hit the
temperature set point you choose.
• In this mode, the fan speed cannot be
adjusted, it starts automatically at a speed
according to the room temperature.
Operating on FAN mode:
• Use this function only when cooling is not
desired, such as for room air circulation
or to exhaust stale air (on some models).
(Remember to open the vent during this
function, but keep it closed during cooling
for maximum cooling efficiency.) You can
choose any fan speed you prefer.
• During this function, the display will show
the actual room temperature, not the set
temperature as in the cooling mode.
• In Fan only mode, the temperature can
not be adjusted.
Operating on DRY mode:
In this mode, the air conditioner will operate
in the form of a dehumidifier. Since the
conditioned space is a closed or sealed area,
some degree of cooling will continue.
(FAN SPEED) Button
Used to select the Fan Speed in four steps
- Auto, Low, Med or High. Each time the
button is pressed, the fan speed mode
is shifted. On Dry mode, the fan speed is
controlled at low automatically.
(ENERGY SAVER) Button
This function is available on COOL, DRY,
AUTO (only AUTO-COOL and AUTO-FAN)
modes. The fan will continue to run for 3
minutes after the compressor shuts off.
The fan then cycles on for 2 minutes
at 10 minute intervals until the room
temperature is above the set temperature,
Auto
Timer
Energy
Saver
Power
Button
LED
Display
Sleep
Mode
Check
Filter
Fan
Speed
Remote
Signal
Receptor
Temp/Timer
Control
Mode
Selector
Temp/Timer
Control
Operating
Instructions