Use And Care Manual

 Page 17 
NOTICE
The front of the Support Bracket
should be located on the indoor side
of the window frame (refer to image
on the left).
Do not place the Horizontal Bracket
and Extension Arms inside the Window
Track where the window sash sits.
B. Move the Angled Support Arms
toward the exterior wall until the
Angled Support Feet touch the
wall. Place a level on a flat area of
the bracket and adjust the Angled
Support Arms so the bracket is
tilted downwards toward the
outdoors to allow condensate to
drain out. The proper angle is
when the level reads 1/4 bubble
(reference image for 1/4 bubble).
Indoor Side Window Frame
C. Insert the Main Support Pin through
the Main Support holes and Angled
Support Arm holes to secure the
Angled Support Arm. Repeat for the
other Angled Support Arm using
the numbers stamped on the Main
Support to help place both Angled
Support Arms in equal locations.
Here is what
1/4 bubble on
the level
should look
like.
Depending on the
level used, place at
either location below
to check level.
Wooden Windows
INSIDE
OUTSIDE
INSIDE
OUTSIDE
Vinyl-Clad Windows
Vinyl Lip
Installation
Instructions
Spring Pin Locks