User Manual

 Page 12 
LED Display:
Shows the set temperature in “°C” or
“°F” and the Auto-timer settings. While
on Fan Only mode, it shows the room
temperature. If the room temperature is
too high or low, it will display “ HI” or “ LO”.
To convert from one to the other, press and
hold the UP (
) and DOWN ( ) buttons
at the same time for 3 seconds.
Error codes:
The unit may stop operation or continue
to run safely. If the error codes appear,
wait for about 10 minutes.
The problem may resolve itself. If not,
disconnect the power, then connect it
again. Turn the unit on.
If the problem persists, disconnect the
power and contact customer service.
Error code appears and begins with the
letters as the following in the window
display of indoor unit:
EH(xx), EL(xx), EC(xx) , PH(xx), PL(xx),
PC(xx).
Display
NOTICE
If your problem persists after performing
the checks and diagnostics above, turn
off your unit immediately and contact
an authorized service center by calling
1-866-646-4332.
NOTICE
If the unit turns off unexpectedly due to
the power being cut, it will automatically
restart with the previous function setting
when the power resumes.
DISPLAYS
Operating
Instructions
9. (SWING) Button
Used to initiate the Auto swing feature.
When the operation is ON, pressing the
SWING button can stop the louver at the
desired angle.
Press SWING button for 3 seconds to
initiate the lter feature. This feature is a
reminder to clean the Air Filter for more
ecient operation. The LED (the light above
the button) will illuminate after 250 hours
of operation.
12
5
3 4
6 7 8 9