Installation Guide

1. Prepare the Bracket – Install Video Time 1:48

The spring push pin on the left

extension arm will utilize the holes on

the right side of the center bracket for

22”-26” wide windows.

NOTE

Remove the top foam insert containing the bracket and hardware from the carton.

A. Measure the inside opening of your window sill and

use that distance to set the total width of the bracket

Extension Arms. To adjust the extension arms, press

the Spring Push Pin, slide the Left Extension Arm out

and then install the Right Extension Arm. Use the short

arm for 22-26” windows, and the long arm for 26-36”

windows.

B. Place bracket on window sill to make sure you have

measured and aligned the bracket arms correctly.

C. Once your bracket arms are properly calibrated, apply

bracket sealing foam strips to the bottom of the bracket

as shown, based on your window type.

Fig. 3

Fig. 1

Horizontal Bracket

Spring Push Pin

Angled Support Arms

Righ

Extension

Arm

Rear Cross

Brace

Main Support

Left

Extension

Arm

Fig. 2

Center

Adjust

Foam

Vinyl Type Windows with a Lipped Sill

Wooden Type Windows with a Flat Sill