User Manual

 Page 10 
NOTICE
For accurate fill levels, ensure the
bucket is empty before beginning
operation.
Fill
level
Models
MAD20S1QWT
Models
MAD35S1QWT
MAD50S1QWT
MAD50PS1QWT
MAD50PS1QGR
1
1.5 gallons
(17 lb)
2.25 gallons
(24 lb)
2
2 gallons
(21 lb)
3 gallons
(30 lb)
3
2.75 gallons
(27.5 lb)
3.75 gallons
(36.5 lb)
4
3 gallons
(29.5 lb)
4.25 gallons
(40.5 lb)
Fill Level Button:
Press this button to change the required
water level before the bucket full switch
activates. The options will fill approximately
to the amounts shown in the table below:
Choose the option which is most
comfortable for you when emptying the
bucket.
When the bucket is full, the Display will
show P2.
The weights above are approximate
weights of the bucket when filled with the
corresponding volume of water.
Timer Button:
Press this button to activate the Timer
function. The Timer LED will illuminate
indicating timer mode is being set.
0.0 will also appear on the display
indicating the number of hours from
now until the timer function will initiate.
When the timer function initiates, the
unit will change its power state. For
more information see Timer function
under other features on the next page.
Bucketless mode:
Bucketless mode allows you to run the
unit without the bucket in place. The
included drain hose or a garden hose
must be attached for proper bucketless
mode operation. To activate bucketless
mode, the following steps must be
completed within three minutes of
plugging the dehumidifier in.
1. Press and hold the up and fill level
buttons for 3 seconds until the
bucketless icon appears on the
display.
2. Ensure the dehumidifier is on flat
level ground (free of debris).
3. Make sure the hose for bucketless
mode does not rise above the
connection point on the unit.
4. Attempting to change the unit into
bucketless mode while it is sitting
on the bucket will have no effect.
To remove the unit from bucketless
mode, place the unit back on the
bucket.
Operating
Instructions
NOTICE
While operating on continuous and Max
modes, the humidity setpoint cannot be
adjusted manually.
Set – The dehumidifier runs until the
humidity setpoint has been reached. The
dehumidifier will begin running once the
humidity rises above the setpoint again.
Max – The dehumidifier will run continuously
on High Fan.
Continuous – The dehumidifier will run
continuously and the fan speed can be
changed in this operating mode.