Operating Instructions and Installation Instructions

3. INSTALLATION METHOD

Fig 3-4

Fig 3-5

4.Wire controller upper part Remove

Insert a flat screwdriver into the slots in the

lower part of the wire controller (2 places).

Remove the upper part of the wire controller

(Fig.3-4)

For surface mounting, fasten the back plate on the wall with the 3

screws (M4x20) and plugs. (Fig.3-5)

Slots

NOTE: The PCB is mounted in the upper part

of the wired controller. Be careful not to

damage the board with the screwdriver.

5. Fasten the wire controller back plate

Back plate

Screws (M4×20)

Connect the female joint of the wires group from the adapter board

with the male joint of theconnective wires group. Next, connect the

other side of the adapter board with the displayboard. (See Fig.3-3(B))

Connect the other side of the connective wires group with the male

joint of the wires group leads from the wire controller. (See Fig.3-3(B))

Install the Adapter Board and the Display Board on the High Wall

(See the Appendix for instructions).