User`s manual

14
English
Storage
Wipe up any moisture inside the hybrid humidifi er body, allow it to dry completely,
pack it back in the original box along with the User’s Manual, and store it in dry
cool place.
Check the following before Requesting Repair or Service
Problem Primary cause Solution
The power does not
turn on.
Is the power cord •
plugged into the outlet?
Plug the power cord into the
outlet.
No mist is generated, or
the amount of mist is
minimal.
Is the Power/Water level •
low (ON/OFF) lit RED?
Is it time to replace the •
ceramic disc (after 3,000
hours of operation).
Fill with water.•
Press the Power button - the •
hybrid humidifier will not
produce mist for about two
minutes – allowing the water
temperature to heat up to
140°F for sterilization.
Replace the ceramic disc (See •
page 12).
Is the Power/Water
indicator (ON/OFF) light
RED even though water
was fi lled.
Is the water tank •
inserted securely in the
hybrid humidifier?
Take out and re-insert the water
tank securely into the humidifi er.
A smell is emitted.
Are you using water •
other than clean tap
water?
Drain the water left in the water
tank, clean product by following
the procedure in the "Cleaning"
section.
The mist nearly stops
once every minute.
This is not a malfunction. •
To prevent water from
collecting at the mist
outlet, the fan motor
stops about once every
minute, and the fan
stops for about two
seconds.
This is a normal operation
function.
MD-KH1001US.indb 14MD-KH1001US.indb 14 2012/04/12 20:59:082012/04/12 20:59:08