Operator`s manual

3—Operating Your HM-Series Camera HM-Series Operator’s Manual
12 Jan 2013
3–2 Installing the Batteries and SD Card
The batteries must be installed and charged before using your
camera. Also install your SD card at this time.
1. To help when removing the
battery cover, remove the
small SD card door. No
tools are required.
2. Loosen the four captive
screws securing the battery
cover.
3. Remove the battery cover by
grasping the front edge
exposed when the card door
was removed.
4. Install the batteries as shown.
5. Iinstall the SD card.
6. Snap the SD card door back into place, ensuring that the rubber
lanyard retracts into the camera.
7. Re-install the battery cover—it only fits one way.
8. Tighten the four screws.
If you have installed rechargeable batteries, they must be charged
before using the camera. Regular AA batteries will provide about one
and a half hours of camera use.
Grasp SD card door edges and pull
Battery
cover
+
–
+
–
–
+
–
+
HM_Series_Operators.book Page 12 Friday, January 18, 2013 4:27 PM