User`s manual

Page 45
• When the update has completed type “bye”, and press the ‘Enter’ key
• If ’put c:\map\mapsnmpfw_XXX.bin’ was not successful then type ”ftp –w:16384 xxx.xxx.xxx.xxx”
and go through the above steps again.
Figure 1: Example of update process for mapsnmpfw_xxx.bin
2.2 Update mapsnmpdata_XXX.bin
• Open a command prompt window
• Type C: and press the ‘Enter’ key.
• Type ftp xxx.xxx.xxx.xxx and press the ‘Enter’ key (where xxx.xxx.xxx.xxx is the IP Address of
the UPS-IPCARD to be updated)
• When prompted enter ’user name’ and press the ‘Enter’ key (default username:admin)
• When prompted enter ‘password’ and press the ‘Enter’ key (default password: admin)
• Type “bin”, and press the ‘Enter’ key.
• Type “put c:\map\mapsnmpdata_XXX.bin”, and press the ‘Enter’ key
• When the update has completed type “bye”, and press the ‘Enter’ key
• If ’put c:\map\mapsnmpdata_XXX.bin’ was not successful then type ”ftp –w:16384
xxx.xxx.xxx.xxx” and go through the above steps again.