Operator Manual
Table Of Contents
- F16, F16R, F24 and F32 Professional Audio Mixing Consoles
- Important safety instructions
- Other important information
- Contents
- Chapter 1: Introduction
- Chapter 2: Getting Started
- Chapter 3: Using The VeniceF With FireWire
- Chapter 4: Working With The Console
- Chapter 5: Mono Input Channel
- Chapter 6: Dual Stereo Input Channel
- Chapter 7: Output Section
- Appendix A: Functional Block Diagrams
- Appendix B: Technical Specification
- Appendix C: Application Notes
- Appendix D: Crib Sheets
- Appendix E: Best Grounding Practice
- Appendix F: Service Information
- FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
36 Chapter 5: Mono Input Channel
VeniceF
Operator Manual
EQ
Each mono input channel of the VeniceF has a four-band, swept EQ, allowing tonal
control over the input signal.
EQ section of the mono input channels
Item Description
1 Treble gain/freq control knob This dual-concentric control knob adjusts
the gain/frequency of the treble EQ:
• gain The top control knob adjusts the gain of the treble band, which is
continuously variable from -15dB to +15dB with a centre detent of 0dB.
• freq The bottom control knob adjusts the centre frequency of the treble
band, which is continuously variable from 2kHz to 20kHz.
2 Hi mid gain/freq control knob This dual-concentric control knob adjusts
the gain/frequency of the hi mid EQ:
• gain The top control knob adjusts the gain of the hi mid band, which is
continuously variable from -15dB to +15dB with a centre detent of 0dB.
• freq The bottom control knob adjusts the centre frequency of the
hi mid band, which is continuously variable from 400Hz to 8kHz.
3 Hi mid width control knob This hi mid control knob adjusts the filter
bandwidth.
4 Lo mid width control knob This lo mid control knob adjusts the filter
bandwidth.
1
2
3
4
5
6
7