Operator Manual
Table Of Contents
- F16, F16R, F24 and F32 Professional Audio Mixing Consoles
- Important safety instructions
- Other important information
- Contents
- Chapter 1: Introduction
- Chapter 2: Getting Started
- Chapter 3: Using The VeniceF With FireWire
- Chapter 4: Working With The Console
- Chapter 5: Mono Input Channel
- Chapter 6: Dual Stereo Input Channel
- Chapter 7: Output Section
- Appendix A: Functional Block Diagrams
- Appendix B: Technical Specification
- Appendix C: Application Notes
- Appendix D: Crib Sheets
- Appendix E: Best Grounding Practice
- Appendix F: Service Information
- FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
Setting up 15
VeniceF
Operator Manual
Setting up
There is no initial setting up required for the VeniceF console. However, if you want to
use FireWire, you will need to set up your PC first (see Chapter 3 "Using The VeniceF
With FireWire" on page 17).
Switching the VeniceF on/off
Switch the VeniceF on/off via the mains switch on the rear panel.
Mains power supply input on the rear panel. A. Mains on/off switch. B. Mains power
supply socket (IEC connector).
A
B