Control Centre Manual
Table Of Contents
- PRO6 Control Centre
- IMPORTANT SAFETY INSTRUCTIONS
- INSTRUCTIONS DE SÉCURITÉ IMPORTANTES
- PRO6 EC-Declaration of Conformity
- Licences
- Precautions
- Recommandations
- Avertissements de sécurité
- Recommandations générales
- Puissance
- Manipulation de l'équipement
- Installation
- Lieu d'installation
- Connexions audio
- Electrostatic discharge (ESD) precautions
- Interférences radioélectriques - Dispositif de Classe A
- Champs électriques
- Équipement de sécurité
- Équipement en option
- Accessoires spéciaux
- Contents
- Overview
- Operation
- Chapter 4: Before You Start
- Chapter 5: Working With The Control Centre
- Chapter 6: Navigation
- Chapter 7: Patching
- Chapter 8: Basic Operation
- Setting a mic amplifier’s input gain
- Setting the high and low pass filters
- Input equalisation (E zone)
- Input dynamics processing (D zone)
- Output processing
- Using VCA/POP groups
- Setting up a mix
- Using fader flip
- Setting up the effects rack
- Simple routing to master stereo outputs
- Scene and show management (automation)
- Configuring the inputs and outputs
- Using copy and paste
- User library (presets)
- Surround panning
- Two-man operation
- Saving your show files to a USB memory stick
- External AES50 synchronisation
- Security (locking mode)
- Connecting And Setting Up The System
- Appendices
74 Chapter 9: Setting Up The System
PRO6 Control Centre
Quick Reference Guide
Switching the control centre on/off
Carry out the following to switch the control centre on or off in a safe manner,
observing all WARNINGS and Cautions.
>> To switch on the control centre
Caution (1)!
A minimum of two power supply modules must be supplying power
to the control centre for correct operation.
Caution (2)!
Before switching on, check that all monitor loudspeaker power
amplifiers are turned off or muted.
After connecting up the audio cables, carry out the following:
Switching on the control centre
1 Plug the three mains cables into the mains power outlets.
2 Observing Caution (1)! above, plug the Volex connectors (see “Wiring
instructions” on page 71) of the mains cables into the mains sockets on the rear
of the control centre. (The green LED next to each mains socket will illuminate if
its mains supply is on.)
3 Observing Caution (2)! above, apply power to the control centre by switching
the D.C. POWER switch on. The control centre will boot up and, when the
default GUI screens are displayed, it is ready for use.
>> To switch off the control centre
1 Make sure you have saved any shows, scenes or settings you require (see
“Saving your show files to a USB memory stick” on page 67).
2 At the GUI, choose homePreferencesShutdown System.
3 At the Shutdown ENTIRE system? prompt, click OK.
4 After the shutdown sequence has finished, switch off the D.C. POWER switch
(rear of control centre).
5 Disconnect the mains cables from the rear of the control centre.
Mains
plug
Mains
outlet
Rear of control centre
1
2
3
Mains power on/off LED indicator