Control Centre Manual
Table Of Contents
- PRO6 Control Centre
- IMPORTANT SAFETY INSTRUCTIONS
- INSTRUCTIONS DE SÉCURITÉ IMPORTANTES
- PRO6 EC-Declaration of Conformity
- Licences
- Precautions
- Recommandations
- Avertissements de sécurité
- Recommandations générales
- Puissance
- Manipulation de l'équipement
- Installation
- Lieu d'installation
- Connexions audio
- Electrostatic discharge (ESD) precautions
- Interférences radioélectriques - Dispositif de Classe A
- Champs électriques
- Équipement de sécurité
- Équipement en option
- Accessoires spéciaux
- Contents
- Overview
- Operation
- Chapter 4: Before You Start
- Chapter 5: Working With The Control Centre
- Chapter 6: Navigation
- Chapter 7: Patching
- Chapter 8: Basic Operation
- Setting a mic amplifier’s input gain
- Setting the high and low pass filters
- Input equalisation (E zone)
- Input dynamics processing (D zone)
- Output processing
- Using VCA/POP groups
- Setting up a mix
- Using fader flip
- Setting up the effects rack
- Simple routing to master stereo outputs
- Scene and show management (automation)
- Configuring the inputs and outputs
- Using copy and paste
- User library (presets)
- Surround panning
- Two-man operation
- Saving your show files to a USB memory stick
- External AES50 synchronisation
- Security (locking mode)
- Connecting And Setting Up The System
- Appendices
46 Chapter 8: Basic Operation
PRO6 Control Centre
Quick Reference Guide
Input dynamics processing (D zone)
Set up compressor and gate dynamics processors using the controls in the input
channel strip’s D zone.
There are four compressors available, corrective, adaptive, creative and vintage, each
with the option of hard knee, medium knee and soft knee.
>> To set up a compressor/limiter
1 In an input fast strip, press the compressor quick access button in the comp
section. This will select the channel and assign its compressor processing area to
the GUI channel strip.
2 In the comp section, press ON to switch the compressor in.
3 In the D zone, operate the attack, ratio/range (ratio), release, threshold and
make up controls to apply processing. You could also set up a limiter by using a
high threshold and a steep ratio (greater than 5:1).
The hold control knob has no affect as it is only used for the gate.
4 Press KNEE to audition the
different algorithms (hard
knee, medium knee and soft
knee as shown right).
Compressor quick
access button
D zone
Input fast
strip
GUI channel strip
Gate quick access
button
Graphs show the effects of
compression/gating
Soft
Medium
Hard