Control Centre Manual
Table Of Contents
- PRO6 Control Centre
- IMPORTANT SAFETY INSTRUCTIONS
- INSTRUCTIONS DE SÉCURITÉ IMPORTANTES
- PRO6 EC-Declaration of Conformity
- Licences
- Precautions
- Recommandations
- Avertissements de sécurité
- Recommandations générales
- Puissance
- Manipulation de l'équipement
- Installation
- Lieu d'installation
- Connexions audio
- Electrostatic discharge (ESD) precautions
- Interférences radioélectriques - Dispositif de Classe A
- Champs électriques
- Équipement de sécurité
- Équipement en option
- Accessoires spéciaux
- Contents
- Overview
- Operation
- Chapter 4: Before You Start
- Chapter 5: Working With The Control Centre
- Chapter 6: Navigation
- Chapter 7: Patching
- Chapter 8: Basic Operation
- Setting a mic amplifier’s input gain
- Setting the high and low pass filters
- Input equalisation (E zone)
- Input dynamics processing (D zone)
- Output processing
- Using VCA/POP groups
- Setting up a mix
- Using fader flip
- Setting up the effects rack
- Simple routing to master stereo outputs
- Scene and show management (automation)
- Configuring the inputs and outputs
- Using copy and paste
- User library (presets)
- Surround panning
- Two-man operation
- Saving your show files to a USB memory stick
- External AES50 synchronisation
- Security (locking mode)
- Connecting And Setting Up The System
- Appendices
30 Chapter 6: Navigation
PRO6 Control Centre
Quick Reference Guide
>> To navigate a mix bus to the control surface
Do one of the following:
• Scroll to the desired mix bus using the scroll by 1 buttons in the mix section. Mix
bus selection follows the scrolling.
• Scroll the desired bank of mix buses to the control surface using the scroll by 8
buttons in the mix section.
>> To select a mix bus
Do one of the following:
• Scroll buttons Scroll to the desired mix bus using the scroll by 1 buttons in the
mix section. Mix bus selection follows the scrolling.
• Touch sensitive control knobs With the desired mix bus assigned to the mix
section on the control surface, touch/operate its control knob.
>> To navigate the mix bus processing area to the channel strip
Press the quick access button in the mix section of the desired input fast strip. This
does not affect the current population of the output fast zone.
You can select an aux bus or matrix bus processing area on the GUI by clicking on the
title of the desired bank of mix buses in the input channel overview of the GUI
channel strip (see Figure 12, “Typical sends sections of the mixes in the GUI channel
strip,” on page 50).
5 Display Shows the number of the currently selected mix bus
and its type.
6 FLIP button See “Controlling the mix buses in flip mode” on
page 18.
Item Element(s) Description