Control Centre Manual
Table Of Contents
- PRO6 Control Centre
- IMPORTANT SAFETY INSTRUCTIONS
- INSTRUCTIONS DE SÉCURITÉ IMPORTANTES
- PRO6 EC-Declaration of Conformity
- Licences
- Precautions
- Recommandations
- Avertissements de sécurité
- Recommandations générales
- Puissance
- Manipulation de l'équipement
- Installation
- Lieu d'installation
- Connexions audio
- Electrostatic discharge (ESD) precautions
- Interférences radioélectriques - Dispositif de Classe A
- Champs électriques
- Équipement de sécurité
- Équipement en option
- Accessoires spéciaux
- Contents
- Overview
- Operation
- Chapter 4: Before You Start
- Chapter 5: Working With The Control Centre
- Chapter 6: Navigation
- Chapter 7: Patching
- Chapter 8: Basic Operation
- Setting a mic amplifier’s input gain
- Setting the high and low pass filters
- Input equalisation (E zone)
- Input dynamics processing (D zone)
- Output processing
- Using VCA/POP groups
- Setting up a mix
- Using fader flip
- Setting up the effects rack
- Simple routing to master stereo outputs
- Scene and show management (automation)
- Configuring the inputs and outputs
- Using copy and paste
- User library (presets)
- Surround panning
- Two-man operation
- Saving your show files to a USB memory stick
- External AES50 synchronisation
- Security (locking mode)
- Connecting And Setting Up The System
- Appendices
Precautions xiii
PRO6 Control Centre
Quick Reference Guide
case the user will be required to correct the
interference at his own expense.
Electric fields
Caution:
In accordance with Part 15 of the FCC
Rules & Regulations, “… changes or
modifications not expressly approved by
the party responsible for compliance could
void the user's authority to operate the
equipment.”
Should this product be used in an
electromagnetic field that is amplitude
modulated by an audio frequency signal (20Hz
to 20kHz), the signal to noise ratio may be
degraded. Degradation of up to 60dB at a
frequency corresponding to the modulation
signal may be experienced under extreme
conditions (3V/m, 90% modulation).
Safety equipment
Never remove, for example, covers, housings or
any other safety guards. Do not operate the
equipment or any of its parts if safety guards
are ineffective or their effectiveness has been
reduced.
Optional equipment
Unless advised otherwise, optional equipment
must only be installed by service personnel and
in accordance with the appropriate assembly
and usage regulations.
Special accessories
To comply with part 15 of the FCC Rules, any
special accessories (that is, items that cannot be
readily obtained from multiple retail outlets)
supplied with this equipment must be used with
this equipment; do not use any alternatives as
they may not fulfil the RF requirement.