Operator Manual

Output channel configuration controls 279
PRO2 Live Audio System
Owner’s Manual
Output channel configuration controls
There are a number of output channel controls that are loosely termed ‘channel
configuration’ controls. The following table shows the configuration controls available
on each output and references the pertinent section within this chapter.
Table 13: Output channel configuration controls
4 FADER/[FDR] switch, switches fader safe on so that the fader is removed
from scene recall.
5 MUTE/[MTE] switch, switches mute safe on so that mute is removed from
the scene recall and auto-mute action.
6 AUTO/[AUT] switch, switches auto safe on so that the channel is removed
from scene recall (this does not affect the action of the auto-mutes and VCA
control groups) and control is removed from VCA control group faders.
7 Fader for adjusting output signal level. Has the same function as the level
control knob (see item 3).
8 Solo B switch (GUI only), changes the operation of the SOLO switch so that
it routes signals to the Monitor B section of the control centre.
Channel controls Aux Matrix Master Refer to
Output channel ID Yes Yes Yes Page 280
Output channel
source/destination
Destination Destination Destination Page 280
Stereo linking Yes Yes Yes Page 280
Mix Yes N/A N/A Page 280
Link fader N/A Yes N/A Page 280
Bus trim Yes Yes Yes Page 280
Direct input Yes Yes Yes Page 281
Safes (EQ,
dynamics, mic,
auto, mute and
fader)
All six All six All six Page 281
Insert Yes Yes Yes Page 281
Delay Yes Yes Yes Page 281
Processing order Yes Yes Yes Page 281
Item Description