Manual

85 PRO X User Manual
Chapter 14: Monitors
And Communications
This chapter describes the monitoring and communications functions of the
PRO Series.
Monitors (A and B)
To match the two-bus solo system there are two monitor outputs, A and B, which
control their respective output levels. These are controlled from the monitor
section on the master bay (see Figure 20 “Monitor A and B strips”). Each monitor
output has:
• The ability to monitor mono and stereo outputs, and an external input.
• An external talkback input.
• A local monitor output.
• A headphone output.
• Delay compensation.
• Control of the solo buses.
• Stereo GEQs for A and B.
Although the capabilities of both monitors are the same, monitor A is the primary
output. They both have a fader control, and there are six balanced XLR outputs
on the rear panel (see “Monitor and assignable outputs/surround section”
in chapter 29).
The monitor output controls do not have support from the screens and are not
aected by automation.
The analogue section of monitor has six balanced XLR outputs. These feed the six
speaker XLRs and two headphone sets. Monitor inputs are fed from the router/line
I/O module that contains digital solo source signals etc. converted to analogue,
as selected on the control surface.
Only the meters have GUI support. The monitor a and monitor b meters monitor
the peak signal levels of stereo left and right for both monitor paths. The metering
capabilities of both monitors the same.
>> To switch control of headphones to fader Press C/O.
5 6
3
4
11
10
9
8
7
5
21
Figure 20: Monitor A and B strips