Manual

55 PRO X User Manual
About the conguration window
The conguration window, which has a similar format for each device, comprises
eight channel panels and drop-down lists for channel range/card selection.
Typical device conguration window
Item Description
1 Device ID eld, contains the device type and number.
2 Device drop-down list, for device selection.
3 Channel range/card selection list.
4 CLOSE button, closes the conguration window.
5 Channel panel, contains device-specic controls and graphics.
Device conguration procedure
Although the procedure for conguring the devices is similar, their parameters
are dependent on device type. The procedure for conguring the devices of a
similar type involves:
• Opening the conguration window of the device.
• Selecting one of the device’s cards/channel ranges and conguring the
available parameters.
• Repeating for the other cards/channel ranges of the device.
• Repeating for the other devices of a similar type.
• Closing the device’s conguration window.
Note: As the set-up procedure is similar for each device (although some of the
options may vary), only the one for DL351 Modular I/O is detailed in this section.
>> To open the conguration window of a device
Click the device’s spanner button.
>> To set up/change the conguration of an I/O device
1. Open the conguration window of the I/O device you want to congure.
2. Select the I/O device from the drop-down list at the top of the
conguration window.
3. Select the card/channel you want to congure/change, via the drop-down
list at the upper-right corner of the conguration window. For example,
the “Analogue In Card”.
4. In a channel, congure the parameters. For example, in channel “In1”, adjust
the gain and switch the +48V phantom voltage on (shown below).
5. Repeat step 4 for the other channels in the card.
6. Repeat step 3 to step 5 for the other cards.
7. If necessary, congure other I/O devices by repeating step 2 to step 6.
8. Click CLOSE.