Manual

32 PRO X User Manual
Setting up the ID of the unit(s)
After connecting up your system, you may need to set up the ID of the unit(s) in
the rack, such as the DL351 Modular I/O, DL451 Modular I/O or DL431 Mic Splitter,
as each unit must have its own unique ID number. After changing ID or sample
rate/clock, a power cycle is recommended.
Note: The I/O unit doesn’t have to be connected in the system for you to set up its ID,
as the procedure can be carried out oine.
>> To set up the ID of an unit
Although the programming menu of each type of I/O unit may look slightly
dierent, the procedure for setting up its ID is basically very similar. For full
instructions on how to set up the ID of each particular I/O unit, refer to its
operator manual.
1. If necessary, switch on the I/O unit.
2. Press MENU and hold for approximately two seconds to enter the main menu.
3. If necessary, use the down arrow button to navigate to the set ID option.
4. Press SELECT to enter the set ID option.
5. If necessary, use the down arrow button to navigate to the desired
ID number.
6. Press SELECT to select the ID number.
7. Press MENU repeatedly to exit the main menu. (The unit will automatically
exit programming mode after 20 seconds of inactivity, that is, if none of the
programming buttons are pressed within that time.)