Manual

253 PRO X User Manual
Appendix K: Parameters Aected ByScope
This appendix shows the parameters aected by scope.
Note: The parameter areas for the scopes (recall and store) and the safes are basically the same. However, the way they are presented in this manual in their respective
appendices is dierent. This may provide you with a useful alternative when referring to this material, should you prefer one more than the other (seeAppendix M
“Parameters Protected By Safes”).
Introduction
This appendix shows you which parameters are or are not scoped when you select the parameter sections in the channels, buses, groups, eects and GEQs on the
Recall Scope and Store Scope screens.
There is a section for each area (channel, bus, group, eect and GEQ) on each scope screen, and these sections are then subdivided according to the processing areas in
the fast/channel strips on the control surface and GUI.
The following diagram shows typical examples of PRO X Recall Scope and Store Scope screens (with no parameter sections selected), and the table to the right
shows what the symbols in each section mean. In the table the orange letters in the Ref. column are used in the tables throughout this appendix to help you quickly
identify the parameter sections.
In the tables in this appendix: Yes = scoped, No = not scoped and N/A=notapplicable.