Manual

199 PRO X User Manual
Item Control Function
1 MUTE switch
Mutes all post-processing signals leaving the channel. (In addition to scene recall, muting can be remote from the auto-
mute masters.)
2 LEDs These safe LEDs illuminate when their associated safe is on.
3
level control
knob
Adjusts the output signal level. In the masters section (master bay), this is a fader.
4 SOLO switch Activates signal routing to the monitor A section of the control centre.
5
FADER/[FDR]
switch
Switches fader safe on, so that the fader is removed from scene recall.
6
MUTE/[MTE]
switch
Switches mute safe on, so that mute is removed from the scene recall and auto-mute action.
7
AUTO/[AUT]
switch
Switches auto safe on, so that the channel is removed from scene recall (this does not aect the action of the auto-mutes
and VCA control groups) and control is removed from VCA control group faders.
8 Fader Adjusts output signal level. Has the same function as the level control knob (see item 3).
9
B switch (GUI
only)
This solo B switch changes the operation of the SOLO switch so that it routes signals to the Monitor B section of the
control centre.
10 Meter Output signal level meter.
11
Red on/o
indicator
Illuminates when mute is on.
12
Blue on/o
indicator
Illuminates when solo B is on.
13
Yellow on/o
indicator
Illuminates when solo on.
Output channel conguration controls
There are a number of output channel controls that are loosely termed ‘channel conguration’ controls. The following table shows the conguration controls available
on each output and references the pertinent section within this chapter.
Table 20: Output channel conguration controls
Channel controls Aux Return Matrix Master
Output channel ID Yes Yes Yes Yes
Output channel source/destination Destination Source Destination Destination
Stereo linking Yes Yes Yes Yes
Gain swap N/A Yes N/A N/A
Mix Yes N/A N/A N/A
Input mode N/A Yes N/A N/A
Link fader N/A N/A Yes N/A
Bus trim Yes N/A Yes Yes
Direct input Yes N/A Yes Yes
Safes (EQ, dynamics, mic, auto, mute
and fader)
All six
Five only
(excluding dynamics)
All six All six
Insert Yes
N/A (on separate
processing area)
Yes Yes
Delay Yes N/A Yes Yes
Processing order Yes N/A Yes Yes