Manual

196 PRO X User Manual
Item Control Function
7
ratio/range/
[ratio] control
knob
This compressor control adjusts the amount of compression applied to signals above threshold.
Range is from innity (∞) to 1:1. When set to maximum (1:1), sets compressor to limiter mode.
8
attack control
knob
This compressor control adjusts the time it takes the compressor to respond after an over-threshold signal. Range is from
0.2ms to 20ms (milliseconds).
9 MODE switch
Selects compressor mode from the ve compressor types available (see “PRO Series compressor modes (dynamic)” in
Appendix A).
10
release control
knob
This compressor control adjusts the time it takes the compressor to recover after programme material falls back below
threshold. Range is from 0.05s to 3.00s (seconds).
11 Meter Compressor ‘gain reduction’ meter.
EQ (E zone)
For tonal control of the aux, matrix and master output signals, the output
channel EQ has the option of a six-band sweep parametric EQ (PEQ) or an
assignable graphic EQ (GEQ).
PEQ
The parametric EQ section (E zone) of the channel strip (mix and master bays)
allows tonal control of the input signal. The E zone contains all of the PEQ
controls, along with a shelving mode selection button and another set of band
selection buttons.
All of the outputs, except returns, have six-band PEQs. Two of the six bands have
three shelving modes each, while another has just one. Any combination of
the six bands can be used to control the signal, although only one band can be
adjusted in the E zone at any time. However, the EQ processing area (GUI channel
strip) displays four bands at any time, and also has navigational controls.
The returns have a four-band PEQ, which is similar to that used on the inputs.
For information, see “EQ (E zone)” in chapter 30.
PEQ sections for the output channels on the control surface and GUI