Manual

194 PRO X User Manual
Output metering
Signal level monitoring of the outputs is only available on the GUI via both
default screens, Overview and Meters. These screens have meters, which look
similar to the ones in the input fast strips on the control surface. For more details,
see “Input metering” in chapter 30 and “GUI” in chapter 3.
Talk
There is a talk switch in each output fast strip and also on the output ‘overview’
displays in the GUI channel strip.
If the TALK/[TLK] switch in the talk mic section is active, the talk buttons will
illuminate to prompt the operator to select a bus that the talk signals should be
routed to. These are also used to set up a talk group after pressing one of the
talk/osc routing panel buttons.
Dynamics and EQ
The control surface has a combined dynamics and EQ section that contains DYN
and EQ on/o buttons, and a listen LED (yellow) that illuminates when listen is
active in the output processing area to show when a channel has its dynamic side
chain soloed.
In the GUI channel strip overview display the aux, matrix and master outputs
each have a compressor section and an EQ section (both are highlighted in the
diagram below). Return outputs only have an EQ section. Clicking within either of
these sections will open their respective processing areas, which are described in
the following subsections.
Figure 39: Dynamics and EQ areas for the output channels on the control surface and GUI
Compressor section
EQ section
D zone
E zone