Manual

15 PRO X User Manual
Audio connections
To ensure the correct and reliable operation of your equipment, only high quality,
balanced, screened, twisted pair audio cable should be used.
XLR connector shells should be of metal construction so that they provide a
screen when connected to the control centre and, where appropriate, theyshould
have Pin 1 connected to the cable screen.
Electrostatic discharge (ESD) precautions
Observe full electrostatic discharge (ESD) — also known as
“anti-static” — precautions when carrying out procedures in
this manual that are accompanied by the ESD Susceptibility
Symbol (shown above). This caution symbol shows you that ESD damage may
be caused to items unless proper ESD precautions are taken, which include the
following practices:
• Keep the work area free from plastic, vinyl or styrofoam.
• Wear an anti-static wrist strap.
• Discharge personal static before handling devices.
• Ground the work surface.
• Avoid touching ESD-sensitive devices.
Radio frequency interference—Class A device
This equipment has been tested and found to comply with the limits for a ClassA
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Electric elds
Caution: In accordance with Part 15 of the FCC Rules & Regulations,
“… changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.”
Should this product be used in an electromagnetic eld that is amplitude
modulated by an audio frequency signal (20Hz to 20kHz), the signal to noise
ratio may be degraded. Degradation of up to 60dB at a frequency corresponding
to the modulation signal may be experienced under extreme conditions
(3V/m,90%modulation).
Safety equipment
Never remove, for example, covers, housings or any other safety guards. Do not
operate the equipment or any of its parts if safety guards are ineective or their
eectiveness has been reduced.
Optional equipment
Unless advised otherwise, optional equipment must only be installed by
service personnel and in accordance with the appropriate assembly and
usageregulations.
Special accessories
To comply with part 15 of the FCC Rules, any special accessories
(thatis,itemsthat cannot be readily obtained from multiple retail outlets)
suppliedwiththis equipment must be used with this equipment; do not
useanyalternatives as they may not full the RF requirement.