Manual

138 PRO X User Manual
Manually controlling a crossfade
The controls in the automation section of the output bay let you manually override the crossfade, as described in the following table.
Control Function during crossfade
cancel button
Pauses the crossfade. Pressing the cancel button again, while the crossfade is paused, cancels the crossfade.
Note: The level of the control on which the crossfade is operating will remain at the point at which it was paused.
If you restart the crossfade the control will travel over the full crossfade period, that is, if you stop (rather than pause)
a ve-second crossfade at two seconds and restart it, it will take the control ve seconds to move to the nal position,
and not three seconds.
now button Pressing this button while the crossfade is paused (by pressing the cancel button), continues the crossfade.
ok button Jumps to the end of the crossfade, eectively cancelling the remaining time to the end of the crossfade.
Jogwheel
Rotate the jogwheel to slow down/speed up the rate of crossfade. The speed of rotation will determine the rate
of crossfade. Rotating the jogwheel quickly in a clockwise direction will speed up the crossfade and rotating it an
anti-clockwise direction slows it down.