Manual

50 DIGITAL RACK MIXER M32R User Manual
Dual Tube Stage / Stereo Tube Stage
Tube Stage / Overdrive is a versatile eect capable of emulating a variety of
modern and classic tube amps. Available in stereo and dual-mono versions,
use Tube Stage / Overdrive to dial in warm and fuzzy sounds from subtle to
fully-saturated.
DRIVE adjusts the amount of harmonics being driven by the eect. EVEN and
ODD adjusts the amount of even and odd harmonics. GAIN adjusts the output
gain of the eect. LO CUT sets the input frequency below which the source
signal will not pass through the eect. HI CUT sets the input frequency above
which the signal will not pass through the eect. BASS GAIN/FREQ adjusts a
low-shelving lter at the output of the eect. TREBLE GAIN/FREQ adjusts a
high-shelving lter at the eect’s output.
Dual Pitch Shifter / Stereo Pitch
Pitch sifting is often used in two dierent ways; one is to set the MIX control
lower and only use the CENT control to make a small oset in pitch between
the wet and dry tones. This results in a ‘voice doubling’ eect that thickens the
overall sound in a more subtle way. The extreme use of this eect is to turn
the MIX control fully-clockwise so that the full sound is aected. This way,
the signal can be shifted into other keys up to an octave above or below the
original key. When used on a voice, it results in a ‘chipmunk’ sound or a low,
‘Darth Vader’ eect.
When the SEMI and CENT push encoders are set to 12:00, the pitch is
not altered. Making adjustments by semitone will have a very pronounced
eect, whereas changes to the CENT control will be very minor. The DELAY
control creates a time dierence between the wet and dry sounds. The LO
CUT and HI CUT push encoders allows the aected signal to be band-limited.
The Dual-Pitch eect allows the left and right channels to be adjusted
independently, and allows gain compensation and panning of the two channels.
3. Rear Panel
3.1 MONITOR / CONTROL ROOM OUT
(1) Talkback Microphone Input
Connect a talkback mic via standard XLR cable.
(2) BAL / UNBAL Left & Right Jack Sockets
Connect a pair of studio monitors using standard ¼" cables.
3.2 AC / POWER
(1) Power On / O
Turn the console on and o with the On / O switch.
(2) IEC Power Socket
Connect the console to a mains power supply via the standard IEC
power socket.
3.3 XLR OUT 1-8
Outputs 1-8
Send audio to external equipment using XLR cables. Outputs 7 and 8 by default
carry the main stereo bus signals.
3.4 XLR IN 1-16
Inputs 1-16
Connect audio sources via XLR cables.
(1)
(2)
(1)
(2)