Operation Manual

4 Chapter 2: Front Panel
DL471 DSP
Operator Manual
Ethernet control panel
The Ethernet control panel has two green LEDs, X and Y, which
illuminate to indicate link status, as follows:
• LED illuminated = good
• LED extinguished = bad
• LED flashing = data activity.
Cobranet audio panel
The Cobranet audio panel has two green LEDs, X and Y, which
illuminate to indicate Cobranet traffic. (This is not normally
used.)
AES50 audio panel
In the AES50 audio panel, both X and Y networks have a green
ok LED and a red error LED, which show the status of the link to
the X and Y routers. Their functionality is similar to that of the
four square LEDs between the two AES50 audio EtherCon® XLR
sockets on the rear panel (see “Indicators” on page 6).
link sync panel
The link sync panel has master and slave monitoring LEDs.
Each has a green ok LED and red error LED that illuminate to
show that the communications to these channels is ok or that
there is an error, respectively.