User Guide

so
i
mute
solo
A
10
10
5
5
0
20
30
40
50
60
dB
The grand master A and B vca
SOLO switches are used to
monitor the grand master A and
B VCA sub groups by creating
a corresponding AUDIO sub
groups on the stereo AFL
busses. All AUDIO sub groups
that are assigned to grand
master vca A or B will be
summed onto the solo busses
when the vca solo is active.
Note i. When a grand master vca solo
switch is active the PFL buss also
receives signals but they are NOT a
true representation of the relative
levels within the grand master vca sub
group. This feature is however useful
as it allows confirmation of signal
present and signal quality when the
grand master vca fader is down or
muted. It is therefore important to
know the status of the PFL
MONITOR switch on the COMMS
module before using the grand master
vca solo switches.
The ISOlate A and B switches
disconnect the grand master
vca A and B sub group faders
and mutes from automation
screen recall. Screen storage
is still active.
The vca MUTE A and B
switches mute any AUDIO
group post fader signals
which are assigned to the
grand master A or B vca sub
groups.
The grand master A and B
VCA GROUP faders are
motorised and under
automation control. They give
continuous adjustment of the
grand master vca sub group
gains from +10dB to off.
23
Note ii. If a grand master vca solo
switch is pressed for a short time it
will latch on or off, but if it is held on
for more than 1 second the latching is
disabled and when the switch is
released the solo will turn off.